Sunday, 21 July 2013

DIY Flower Crown

                        DIY Flower Crown 


Supplies

step one: create a circle that fits comfortably around your head, that is easy to take on and off. i tripled the amount of wire and then wrapped a fourth time around to make it extra sturdy.
step two: cut your first bloom and place it in the desired direction on the crown. using a small 4 inch piece of wire, wrap the bloom tightly with wire to the circle with pliers.

continue doing so with more blooms, layering the flowers on top and side by side one another until you start to build a full crown of pretty flowers.
you can continue all the way around the circle and fill the entire crown with flowers or leave about one third of the crown empty as i did with my crown. if you do decide to leave an open space on your crown you will want to wrap the exposed wire with floral tape and i did below.
 the floral tape is slightly sticky so tightly wrap the exposed wires together from one end to the other.
Five

No comments:

Post a Comment